WillianFB wrote:

sorry for the double post but my locknuts get stucked cuz they so small to the tool
like the tool dont fit the nut anymore so it get stucked
help me please
fast!!!

My friend showed me this yesterday, haha!

Place the tool tilted (like angled 70-80 degree) on the locknut, and drag it of. Btw you can use a plier too. If it is the one in the wheels, I can´t help you.

I have to angle my tool a bit to get some nuts off the 2nd hand BRTs I bought, the nuts are a bit rounded, but tilting the tool on the nut a little bit then turn and they come off fine.

can anyone recommend me on what type of cement and sand to use for making a cement fingerboard park, and the ratio of cement:sand

Can someone please post or pm me the side concave on a berlinwood 33.3 compared to the wl please?

idk if that helps, here's a pic of the BW 33.3
I don't have a WL to compare, but you can find those shapes here.

does the Y-tool have a smaller outer-diameter than the BRR/TD-tools?
I mean, does it fit completely into Oaks, to screw them on properly?

Jack B. wrote:

can anyone recommend me on what type of cement and sand to use for making a cement fingerboard park, and the ratio of cement:sand

Seems like people us Portland cement or powder fine mason/mortar mix. Those are the two that I've seen mentioned in concrete park and bowl tutorials. Based on my experience when I worked in a hardware store, you would be better off with getting both. Use the fine mason mix as the base layer for everything and skim coat/finish off with the Portland cement (which is concrete without the sand, super smooth but not as strong structurally). Then follow the finishing instructions of primer, paint/garage floor finish, etc to whatever you want it to come out as.

Can anybody with a klotz block tell me the length, width, and height of one?

thanks kthumb and levelup !!

Jack B. wrote:

Can someone please post or pm me the side concave on a berlinwood 33.3 compared to the wl please?

http://berlinwood.com/board-shapes/

If that doesn´t help, I can send you a pic with BW classic, Wide Low, Wide and Extra Wide later today

I've heard that the Y Truck X4's are quite light.. Is the word on the street true?
( Compared to BRT's. Possibly as light as plain old china trucks? )
Thanks!

YTrucks are lighter than BRTs, yes. But i don't think they're as light as old chinas.

I'm looking for a square low rail, do you know a few brand that have them in stock?

i think my axles in my brt wides are broken, what should i do??

movin-like-burnie wrote:

i think my axles in my brt wides are broken, what should i do??

Cry... A lot.

you think or you know? pull it out and look if it's broken

How long is Ace Tape V3?

110mm I believe

jacobdonut wrote:

How long is Ace Tape V3?

Confirmed: 40mm wide x 110mm long (+/- 1mm)
I measured all 3 of my sheets and you can tell the ends are cut off a roll and sometimes a little slanted.

Does anybody know who makes custom woodprint decks?

What colour of witchcrafts would go best with the bw 33.3 blue and yellow anchor graphic? Blue or yellow?

Yellow imo

Yellow wcs

Any tips for how to use ywheels on brt's?

From Fingerboarding Confessions Thread:

Tomé Martins wrote:

Fujykky wrote:

Tome i've seen ywheels on brts but u have to pull the outer bearing off from the wheels

I feel like I'm going to mess it up so...

Are you looking for additional suggestions or help removing the outer bearing?