Well more of a hardware issue.
So I have some china wides, I've been shaping them and planned on painting them. The process I'm using to shape them is very slow, so I've missed actually skating my setup. I decided to take a break from shaping, put the half-shaped trucks back on and ride it for a little bit.
I was putting on my last wheel and about half way on, I realised that the nut was barely moving, it was stripped. So now one of my Roll9's are stuck... It wouldn't be such a big issue to me if the truck wasn't 1/2 shaped. The truck isn't symmetrical and that will drive me absolutely insane.
I spent the last two hours trying to slowly unscrew it- I've gotten it pretty close to the edge, but now it doesn't seem to be moving. I'm not sure what I should do, as they are my only bearing wheels. If you have any suggestions or advice it'd be much appreciated
I might post a picture later, if you want to see, but it's currently 1:45 am my time and I'm tired :3