I am having a huge issue with my bearings moving in the wheel when I fingerboard! I know they are removable but should i put super glue around the outside of the bearing? my backs to them are already coming off because of trucks grinding it down. wanted to make sure it was a good idea before I did it.

if you superglue, being that its insanely hard to do, chances are you'll glue the bearing by accident and fuck them up. How do they slip on normal wides? That doesn't make sense, unless the back has completely worn away?

i use roll 9's..they just act dumb somtimes nad do this...justr keep the whell on the truck and have the both tighted holding the wheel in place pull the wheel hard againgt the bolt (you should hear a small pop) this is what i do..it alwase fixes it

in my experience if your wheels slip, there is pretty much nothing you can do about it.

they will always slip. no amount of fine careful gluing with all of the glues under the sun will sort them....

but you can try if you dont trust my advice.

get duals. no problems.

one back is completely worn but the others have backs

I have flatface ones anyways so whatever I guess

you can edit your posts so you dont double post....in the top right corner of your comment

sowwy ):

haha its ok..I honesly dont care but some people get mad

THis happened to my old bearing wheels. i always had to pull the wheel against the bolt of the truck to pop the bearing back into place. the problem only gets worse the more you do this. i had to trash the wheels because they basically couldnt roll a foot without popping out. its time for some new wheels mate :/

I have g6's to so it's ok

WillSteller wrote:

I have g6's to so it's ok

G6s are the booooooommmmbbbbbbbb

you can try putting a tiny blob of glue on 4 places if the wheel, it holds, bit you need to really careful