I managed to land a kickflip into a mug of coffee. Now I'm not worried about my deck as it's on its way out anyway but I was wondering if my wheels and trucks would be alright?

I dried it off over the toaster!

On the plus side, the coffee tastes nicer.

I dropped my old Berlinwood 2009 with NC v3s in Pepsi, didn't do anything really I just seshed the sink full of water to wash it off, I dropped it in wax aswell, didn't do any harm

Well i spilled glue on my BW complete . The winklers were dead. Then I acidified them with some medical alcohol ... They were as NEW !!!

When I skateboard in the rain, the entire board gets ruined and I usually suffer a hilariously bad injury from the rain making everything slippy. At the very least, wouldn't the bearings be fucked? I hope this doesn't happen to me. :s

look put it this way, my berlinwood went through the washing machine and its fine.

I dropped tea on most of my setups
They were Ok.
For some reason I thought this was a thread about coffee running out
That would make me cry.

Finn S wrote:

For some reason I thought this was a thread about coffee running out
That would make me cry.

now i want coffe

I've dropped boards in several drink substances over the years, and as long as you retrieve it extremely quickly, no harm is done.

"The 5 Second Rule" applies.

I like Trains

I'm sure the bearings + trucks are fine, but yea, deck might go soggy.

The trucks will prob be okay so will the deck, but the bearings, idk...

I've dropped boards in a few drinks including coffie. I dropped my homewood with g7's in my cats water that was the worst. Imedietly after you do something like this hold your board by the heater remove it every couple of seconds (depending on how hot your heater is) so you dont sepperate the glue, adhesives dont like to much heat. This should also help your bearings because there so small they wont hold much water and it should evaperate fast dont overdo it and melt your wheels.

i dropped my bw with G4's in the sink 3 times and it's completely fine, if anything the bearings are better

But my glue issue is the worst. XD

^I stepped on my g12 i think that's a worse story.

2 days ago my mum accidently put my dooby in the washing machine, it's pretty much fine except some lacquer damage, the wheels and trucks are as good as new! haha

Finn S wrote:

^I stepped on my g12 i think that's a worse story.

man that sucks

Finn S wrote:

^I stepped on my g12 i think that's a worse story.

well i guess it is worse :O