Ok so I have a set of Icon wheels, and the washers went completely in the wheel, and no matter what I try I cant get the washers out. Please help

Try with a safety pin or paper clip? Pictures would help

And I have tried both, no luck

Is that the front or back?

Back of course^^

Do you have a picture of this kind of wheel without a washer stuck?

yep

hmm.. I'd try forcing it out with a knife. What's happened is the washer was worn itself into the wheel material. You need to get something in between the washer and the bearing to get it out.

Alright. But how should I go about it with a knife? I don't understand how I should force it out with the knife.

Get the tip of the knife in between the washer and bearing through the axle hole. Don't be afraid to use force.

Put it in the hole and flick it out

Mikkel S wrote:

Get the tip of the knife in between the washer and bearing through the axle hole. Don't be afraid to use force.

Tried, but when I put force on it it still doesn't go

not sure if its magnetic? if so try a strong magnet, or something sticky.. or try the nice thing with a safety pin

Are these the brt edition ones?

No^

Have you tried pushing the washer and bearing out?

Edge of a razor blade???

Have you tried using a paperclip or small screwdriver and put it through the bearing whole on the opposite side to the washer and push the washer out from behind?

yeh i would place a small screwdriver in the front of the wheel and tap the top of the screwdriver with a hammer, forcing the bearing down and the washer out and then you can push the bearing back to its original position

Jack B. wrote:

yeh i would place a small screwdriver in the front of the wheel and tap the top of the screwdriver with a hammer, forcing the bearing down and the washer out and then you can push the bearing back to its original position

Alright I'll try that

Update- Got 3 of the washers out! Just need to get the last 1

That's VERY weird.
I think if you put the tip of the knife in between the washer and bearing a try to push it out, that should work.

Ive tried that multiple times. No luck. Still trying to g et the last one out. Its being a bad boy

Update!-
Got all of the washers out! Thanks everyone for the help!
BTW 1400 Post!

Out of curiousity, are these wheels supposed to be backless? If so, why did you have washers on them? O.o