you don't need to put washers on HP trucks

what are HP trucks?

high performance

which way do you put them on though?
do i put them on with the face with the biggest recess of the bearing towards the axel
or with the face with the less recess of the bearing facing the axel, like you would with a normal wheel?

ummm you put the bigger hole towards so truck and the small hole towards the nut. thats how it goes, they don't make it simple. XD

oh okay i guessed that..i did it right!..the axels still stick out quite a bit though..

ye, mines ok. It doesn't affect the performance, but don't do anymore primo's. It'll ruin your ramps.

I've ordered stuff from No Comply, Redemption, and others but never Flatface. I've been planning on ordering a Blosom from Flatface and some TKY bushings, but I'm out of tape. I was wondering if each deck Flatface sells comes with a piece of tape, or if I should buy some tape?

Well you should buy tape, only some decks come with tape like a berlinwood and a flaked

Blosom don't come with tape.
On the homewood website you can order sheets of foamy g seperetly.


Also do you need to wax harriers?

It's optional, after the it's worn down a bit i'd say wax it then, but just make sure you don't put too much on otherwise you'll cake your trucks

Ok thanks for the addvice Thom

Ok thanks guys

How do you set up a truck with washers? In what order do the washers and bearings go?

the washers go in between the truck and the wheel
they can also go in between the bottom bushing and the truck and in between the top bushing and the nut

what glue do you guys use to glue nuts?

Locite, the one with the long nose and maby the brush. I'd go for any super glue and place it with a tooth pic.

Hope this helps.......

Blue loctite

http://swat.cz/maloobchod/fingerboard_tuning_hardware.php

There's loctite there^

Yeah that stuff would work to.. Intact that looks just like the one I use

are bollie trucks just shaped china trucks?

^yes, they are just china trucks.

Not anymore the 3.0s are really nice trucks (probably shaped shaped wides haha) but they look nicer and skinnier

Rdcruzer wrote:

Not anymore the 3.0s are really nice trucks (probably shaped shaped wides haha) but they look nicer and skinnier

I dont think that blackriver would actually take the time to actually shape trucks, they are more than likley a different type of china trucks.

3.0 blackrivers?????? Where is this?